Blue screen of death

[maverik99]

Hi Techies,

I want help my PC is refusing to start. My config is as follows ( Cel D 2.5, Foxconn 865 Gl/GV, 250 GB SATA(segate), 512(DDR) MB ram.)

The problem startet 2 days before, i was working on an office appllication and PC suddenly restared. Then i was taken to screen where u select safe mode and last good configuration options as soon as select one of them and hit enter PC restarts automatically. I tried to re-install the OS but was in-vein, when i am putting in the bootable XP CD in all the drivers are getting loaded once they are loaded when i am on Set up is installing windows screen i get a blue screen of death.

With error saying ( 0*0000000000 something).
Can someone advice me what could be the problem.

FYI.......i had installed ESET smart security package 2 days before.

Quick replys expected.

[[xubz]]

Well, Just the Hex Number or any DLL/SYS file is mentioned?

Usually, BSODs have a heading.. like for instance, 'IRQL_LESS_OR_NOT_EQUAL', etc.

Can you post that?

I suspect your RAM has gone bad. Try getting a replacement. (Or download Memtest86+ and Test it)

[Nav11aug]

Originally Posted by [xubz]

Well, Just the Hex Number or any DLL/SYS file is mentioned?

yup, the "Hex" number... "casting a hex "

[ravi_9793]

remove all external devices attach like printer, pendrive and all.Also remove graphics card if you have any.Than try to install XP.

If it all fails..than I am scare you hard disk is corrupted.Try to install on another hard disk..and I am sure you will be able to install XP.

Also, care:
1) Have you installed any new hardware in your system.
2) Do fresh installation, avoid repair.
3) Have you updated driver of any new hardware.

[maverik99]

Thanxs guys for your quick reply,

As far as the RAM and Hard disk goes i have tried to replcae both of them i have put in my friends hard disk(Empty) and his rab also 512 MB both are working fine for his PC. The problem is still there. I am not to sure about the hex number, but yestarday i have got this error Page fault in Non paged area.

[shady_inc]

Maybe your RAM has gone faulty.Have a look in the event viewer.[Control panel>Administrative tools>Event Viewer] and check for any red icons there.

[VideoEditingIndia]

If you didn't disable windows minidump, Can you upload your Dump file from C:\WINDOWS\ Minidump\Mini***.dmp

[coolsunny]

I think its might be ur SMPS problem.Can u tell its brand,wattage & other specifications like current under +12v rail...If u can check it with another good SMPS.Its my 1st option.

or u can try this to make ur Bios to default values :

Try to reset ur Bios jumper,its Close to CMOS battery.1st take the battery out & remove the jumper & install it in nearby 2 pins.Means in both cases(set/normal & reset) the middle pin is common.Place it there in reset position.put the battery.Make ur pc ON go to ur Bios(if u be able) by pressing Del key.Make Bios setting Default.save & exit.Now set ur jumper to normal position & Make ur pc ON.it may help u..

& reply wht u get..

[anandk]

The "Blue Screen Of Death".
or
READY-RECKONER : Windows 'Stop Errors' or 'The Blue Screen Of Death'