Problem with my new Machine - Pls Help Urgently..

[amitskale]

Hi Guys,

I built my new pc yesterday. After assembling the pc I started but nothing is happening. No beep is coming from the system.

The config is :

Intel dual core E2140 1.6 GHz
Mercury mainboard with 945 chipset
Dynet ram 1GB @667MHz
Segate Sata2 250 GB
LG 17'' lcd

I checked all connections and they are fine. Processor fan starts immediately after power on but then nothing comes on the screen.

I later removed all devices(like hdd, dvd writer etc) connected and kept only processor and ram on the board but the same story. Later I changed the ram slot but to no avail.

I guess that there is some problem with the mainboard/ram as no beep is coming from the system speaker.

As I know even if there is a problem with the ram the bios and all comes on the screen and then u get some error if its a faulty ram. Am I right/wrong?

I am unable to figure out what might be the problem.

Please help asap! Thanks in advance!

Regards,
Amit Kale.

[sagargv]

i wonder if ur proccy is supported by ur mobo . .

[amitskale]

Oops. Motherboard says that it supports Dual core perfectly and even Core 2 Duo also. compatibility I guess is not a problem.

Regards,
Amit.

[ravi_9793]

yes..all motherboard based on Intel 945 support C2D processor.You dont even listen any beep sounds. Looks like motherboard problem.

Get it checked from the vendor.

[Ponmayilal]

ya, if the RAM is faulty or not recognised by the BIOS you will hear two short and one long beep ( if I remember correct ) and nothing will show up on the monitor.*my personal experience*. Take the motherboard complete with the processor and RAM and have your vendor/service point test it, to pinpoint the problem.

[dearkumar]

listen , unplug the RAM from its slot . can you hear any beeps ?
No . then its the problem for your motherboard . you need to change some capacitors . however you cannot rectify it . service center can do .

If you hear some beeps then its ram problem . take a good eraser and clear up the ram then plug into the slot . if you are lucky then it will be ok . However try using different slots of the mobo . it happened in my case that in mobo one of the slot was bad .