Forum     

Go Back   Digit Technology Discussion Forum > Hardware > Hardware Q&A
Register FAQ Calendar Mark Forums Read

Hardware Q&A Discuss basic Hardware problems, find solutions to your hardware queries which don't fit in the other sections.


Closed Thread
 
LinkBack Thread Tools Display Modes
Old 11-11-2006, 08:26 AM   #1 (permalink)
In The Zone
 
ECE0105's Avatar
 
Join Date: Apr 2005
Location: Hyderabad
Posts: 361
Question P4 2.8 (511) Prescott Temp. and Upgrade.


Hi,

I have a P4 2.8 (511) Prescott with an Intel D101GGc Motherboard.

I happened to see a lot of Dust on the Heatsink Assembly of the processor. I removed it and cleaned it using a Brush....

After putting it back in, I checked the temperature in the BIOS and find that it is 62degrees C.

Is it Normal, or should I clean the processor and put some more paste on it. Please lemme know the correct procedure to do it and can I also put the paste on my RAM, (Just for the heck of it)... Cos, I don't use ACs and the my Cabinet has only two small Fans, on the side panel, just above the processor.

Also, would it be worthwhile to upgrade to a Pentium D processor, the highest which I believe is the 950 with 3.40 GHz and 800 MHz FSB. Or the P4 D-820, cos this retails for around 5,000 in Hyderabad.

My Motherboard Revision is AAD35788-309

What would be the estimated cost of upgrading Only the Processor, I have a PC32000 512MB RAM(Running in Single Channel).

I am not looking at a full upgrade, since I have bought this rig in April this year and Do not wish to spend much, but I still feel that the computer runs quite slow.
ECE0105 is offline  
Advertisements. Register and be a member of the community to get rid of them.
Advertisement

Old 11-11-2006, 08:48 AM   #2 (permalink)
Banned
 
assasin's Avatar
 
Join Date: Oct 2006
Location: Durgapur
Posts: 1,785
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

The temp is quite normal.if u wanna upgrade den buy Pentium D 950 but it wont do u much good.Jst wait 4 few more mnths & upgrade to C2D.
assasin is offline  
Old 11-11-2006, 09:21 AM   #3 (permalink)
In The Zone
 
ECE0105's Avatar
 
Join Date: Apr 2005
Location: Hyderabad
Posts: 361
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

Thanks for the response, could u lemme know how much my present Rig could go for and the best config that I can buy after spending a max of 10k...
ECE0105 is offline  
Old 11-11-2006, 09:52 AM   #4 (permalink)
Banned
 
assasin's Avatar
 
Join Date: Oct 2006
Location: Durgapur
Posts: 1,785
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

Dont sell ur whole rig,just sell the proccy + mobo + RAM.For dat u'll get a max of Rs6000.
C2D E6300 = Rs.9200
Intel D965RY = Rs.6800 or Asus P5B DLX = Rs.11000
Ram: 512 = Rs.3200 & 1GB = Rs5800


AMD Athlon X2 3800+ & Asus M2N-MX = Rs.12600.

If u cant buy the C2D config,u can buy the AMD.It'll give u far better performance dan ur present rig.
assasin is offline  
Old 11-11-2006, 10:21 AM   #5 (permalink)
In The Zone
 
ECE0105's Avatar
 
Join Date: Apr 2005
Location: Hyderabad
Posts: 361
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

Woah !!!!!!

This is way outta my budget. I guess I can go for the AMD, but Will my RAM suffice, cos the prices of RAM are increasing by the day....
Last week, I find the price of Hynix 512 MB (PC3200) for 2,900.
ECE0105 is offline  
Old 11-11-2006, 11:07 AM   #6 (permalink)
Wise Old Owl
 
samrulez's Avatar
 
Join Date: Apr 2006
Posts: 1,342
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

Dood the temp is not normal.....62 IDle!!!!....Man it should be 62-65 @full load........Your processor must be touching 80 at load....
__________________
Sam :D Rulez :lol:
samrulez is offline  
Old 11-11-2006, 11:47 AM   #7 (permalink)
Banned
 
assasin's Avatar
 
Join Date: Oct 2006
Location: Durgapur
Posts: 1,785
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

A Prescott doing 62 C at idle is not dat bad.My previous rig (Pentium D) used to idle at 60 -64 C.

@ECE0105 Even if u buy AMD u'll hav to buy new ram cuz u'll need DDR2 ram
assasin is offline  
Old 11-11-2006, 06:35 PM   #8 (permalink)
In The Zone
 
ECE0105's Avatar
 
Join Date: Apr 2005
Location: Hyderabad
Posts: 361
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

I think the temp thing got fixed....

Just checked and it is idling at around 57 deg. Which I hope is fine.

@ assasin, cud u lemme know which is the fastest DDR2 RAM avl. in the market...
ECE0105 is offline  
Old 11-11-2006, 09:12 PM   #9 (permalink)
Wise Old Owl
 
samrulez's Avatar
 
Join Date: Apr 2006
Posts: 1,342
Default Re: P4 2.8 (511) Prescott Temp. and Upgrade.

@ assasin : Dood, the pentium D has 2 Prescotts glued to gether....It can even take 80degs....Smithfeild...core understand...

For Prescott.....65 at load is recommended....

Quote:
, cud u lemme know which is the fastest DDR2 RAM avl. in the market...
Cellshock...1GHz @4-4-4 !!!! ..2GB kit costs 25k...I think..
__________________
Sam :D Rulez :lol:
samrulez is offline  
Closed Thread

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


 
Latest Threads
- by clmlbx
- by Sujeet
- by trublu
- by icebags
- by ico

Advertisement




All times are GMT +5.5. The time now is 05:20 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2012, vBulletin Solutions, Inc.

Search Engine Optimization by vBSEO 3.3.2