9500GT - No Display

zipzap1 · 23-04-2011, 11:31 AM

Recently i installed a 9500GT nvidia GFX card into my rig :-
AMD 7750 BE @2.7ghz
Jetway PA74M5 mobo
3 Gb ram
320 Gb hard disk
9500GT

Before i could use my new 9500Gt for my Games , i disabled internal graphics option in bios.
Then my pc would not display anything on the screen
I then shifted the jumpers (from 1-2(normal) to 2-3(clear CMOS)
then after resetting the bios, i restarted it usin 1-2 jumper configuration, my pc would not start again (i meant display). then i put the jumper back into 2-3
VOILA..
my computer started alongwith display BUT everytime it starts, it loads default settings with the message "CMOS checksum error"
PLEASE tell me what to do ??
also i replaced the CMOS battery but that went in vain.

thetechfreak · 23-04-2011, 01:00 PM

Your CMOS battery of motherbard may have run out.

Have you connected the monitor the VGA/ HDMI port of the card or IGP?

Is your PSU enough?What PSU do you have

**Krow** · 23-04-2011, 01:29 PM

@zipzap, please give proper thread titles. "Help pleasseee" is not going to help you. Thanks.

zipzap1 · 25-04-2011, 03:40 PM

@tech freak : I have 450 watts psu and I conectd the vga port to graphic card and not IGP,,,,
also I replaced with a new cmos battery and that went in vain

@Krow: I am a new member so I dont know what the,title should I give

thetechfreak · 25-04-2011, 04:04 PM

It might be defective card..try to get it serviced/repaired

Also,I reccomend to use it with another monitor because I feel the card may be outputing resolutions more than supported by monitor

Your mobos graphic card slot maybe at fault.

zipzap1 · 25-04-2011, 06:55 PM

@thetechfreak : dude i also forgot to tell u that after that checksum error PC starts and the games go good, so i dont think that the prob is with graphics card...
and about the mobo, i cant say anything