mt882 using yast 2

[chintanraoh]

hi guys
have any of tried configure bsnl modem using yast 2(suse10.0)?
I tired it but with little success.
i copied the settings of the 'ipconfig /all' in windows to yast
ping command did not work.
ifconfig doesnot contain eth0
thanking you chintan

[QwertyManiac]

USB or LAN?

[chintanraoh]

usb

[QwertyManiac]

Then forget it, its impossible atm...

[gary4gar]

get a lan card just for 150-175rs then it is work of breeze else u have to do a little reseach yourself.

@qwerty
it is possible but is really difficult

[QwertyManiac]

Ok tell me the way if you have discovered it! I didnt say its completely impossible. Just at the moment its not yet known how to config it or other unrecognized USB devices (on new distros)

[cyberzook]

tell about LAN. I have SuSE 10 & UT-300R2 modem

[QwertyManiac]

Follow this

http://www.thinkdigit.com/forum/showthread.php?t=21171

[But I just enabled DHCP and it auto configured the whole net for me :)]

[cyberzook]

I dont want an "always on" connection

[JGuru]

Even Ubuntu uses DHCP and automatically configures. No need to provide
IP address , subnet mask etc., Cyberzook, if you don't want an always on Net
connection, just disconnect the cable jack. That solves your problem.

[QwertyManiac]

:lol: good solution JGuru :lol:

I think KPPPoE or something helps in dial up type connections...