HARDWARE SUPPORT REQUIRED ! can u DIG it ???

[suhas_sm]

My hdd works as fine as nething when i connect it to my friends PC ( boots,loads os,wors properly)
But when i connect to my System - compaq 7000 presario

Problem:
Case1:
:arrow: my bios detects my hdd as 10 gb or 40 gb sometimes
:arrow: next step no operating system found on any drives
Case2:
:arrow: if i use a bootable it says couldnt register
(it states the reson as follows:
1. non-dos fat
2. third party partion manager used
3. virus attack)
:arrow: Fdisk
error reading fixed drive
Case4:
:arrow: knoppix i:couldnt mount
what i could do to help troubleshoot:
:arrow: changed the data cables , changed the bios battery.
:arrow: fixbmr,fixboot
:arrow: formatted in my system as well as my friends pc
can u diagnos it n tell me what the problem could be ???

[suhas_sm]

Any help would b appreciated ! some one ! ne one! ne sugestions ????? :(
me in a desperatre situation now :roll:

[sidewinder]

Almost same happened with me!!!!! I had to change my bios.Get ur mobo checked quickly.And if the repairing cost is too high go 4 a new mobo.Good luck!

[indro]

u need to upgrade your computers bios , thats the bottom line !

[suhas_sm]

well i think the prob is with primary disk controller... :) well that means my mobo :(

[klinux]

check cables , switch ide on m/b ie, from IDE 1 to IDE 2 , change jumbers to cable select . Try detecting them in the bios . connect without a cdrom or slave . try manufacturers disk fitness test . u can check smart status of the disk that way and run short or long surface test through it . most HDD have ontrack disk manager , so u can backup mbr too . try removing any other components like usb devices , nic etc . Some hdd have limitation jumpers . check that out . try connecting both cd/hdd on same cable , on ide 1 and ide2