Digit Technology Discussion Forum - View Single Post

scream4u · 10-01-2008, 11:47 PM

i'm havin a prob here.. i wanted to change the layout in my phone, but when i connect it, as usual, it sends me message below, and after that nothing..

20:14:05| Sending db2020_cid01_prodid_p3j.bin...

EDIT:

i think that the problem is my phone port, where u connect all the cables, coz it doesn't connect the charger.. and earphones play bad too...
so i'm planning on takni' it to the service, mby they can replace it, without the whole motherboard.. and my speaker doesn't work neither, i went to italy this summer, and it fell in sea

but that's ok, it works fine, after flashing too..
so i hope they can change my shitty port

10-01-2008, 11:47 PM	#626 (permalink)
scream4u Right Off the Assembly Line Join Date: Dec 2007 Location: Estonia Posts: 6	Re: Tutorial: Flashing k550i to w610i !! i'm havin a prob here.. i wanted to change the layout in my phone, but when i connect it, as usual, it sends me message below, and after that nothing.. 20:14:05\| Sending db2020_cid01_prodid_p3j.bin... EDIT: i think that the problem is my phone port, where u connect all the cables, coz it doesn't connect the charger.. and earphones play bad too... so i'm planning on takni' it to the service, mby they can replace it, without the whole motherboard.. and my speaker doesn't work neither, i went to italy this summer, and it fell in sea but that's ok, it works fine, after flashing too.. so i hope they can change my shitty port Last edited by scream4u; 11-01-2008 at 12:46 AM.