Digit Technology Discussion Forum - View Single Post - what is "waking connection" in limewire????

tango_cash · 05-07-2006, 01:22 AM

hi
i have a 64kbps brodband connection it is a cable internet connection.i just have a lancard. and i use limewire to dwnlod stuff. since the speed is low i start the dwnlod and switch off the monitor. after some time(like 1hr) when i switch on the monitor and go to limewire then it says "Waking connection" so was it sleeping all that time!!! i checked my power saving settings i have turned all of them to never(monitor/hdd/standby).i also went to lancard's properties>configure>power management and there i unchecked the option "allow the computer to turn off this device to save power".but i still get the "waking connection" message in limewire.the message appears on the bottom left hand side where the connection status is shown(disconected/poor connecton/turbo char.....).

05-07-2006, 01:22 AM	#1 (permalink)
tango_cash In The Zone Join Date: Jan 2004 Posts: 305	what is "waking connection" in limewire????(see the screen shot in the end) hi i have a 64kbps brodband connection it is a cable internet connection.i just have a lancard. and i use limewire to dwnlod stuff. since the speed is low i start the dwnlod and switch off the monitor. after some time(like 1hr) when i switch on the monitor and go to limewire then it says "Waking connection" so was it sleeping all that time!!! i checked my power saving settings i have turned all of them to never(monitor/hdd/standby).i also went to lancard's properties>configure>power management and there i unchecked the option "allow the computer to turn off this device to save power".but i still get the "waking connection" message in limewire.the message appears on the bottom left hand side where the connection status is shown(disconected/poor connecton/turbo char.....). Last edited by tango_cash; 10-07-2006 at 10:59 AM.