Quote:
|
Originally Posted by tech_your_future
It is detected by Ubuntu on parallel port 1. So, I did configure it right in Knoppix too. Now, in Ubuntu even after proper setup, it is shown as ready, whenever I give print a test page command, nothing happens at all. There is no response from the printer.
|
Did it work in Knoppix? How many parallel ports do you have on your system? Do you have proper permissions on /dev/lp0? Change LogLevel in cupsd.conf to debug2 and then try printing again. After it fails, check in /var/log/cups/error_log to see what errors it gives.